You are here

Banana PI Accessories

BPI-M2 Camera interface, The BPI-M2 CSI Camera Connector is a 40-pin FPC connector which cannects to an external camera module with proper signal pin mappings. The pin definitions of the CSI interface are shown as below. This is marked on the Banana Pi board as “CSI”.
Contact us for a quote
contact details

BPI-M2+ support OV5640 camera module can be used for the BPI-M2+ , this camera is not same as BPI-M2,BPI-M1.... , it support OV5640 module, which does not need the extend board, you can plug it onto the board for direct use OV5640 modue on CSI interface. If you have BPI-M1/M1+/M2 camera module ,you can remove camera module from the extended board and it can used on the BPI-M2+.


OV5640 camera R
Contact us for a quote
contact details


BPI-M1/M1+/M2/M3 The 7" LCD Banana Pi Official Display is compatible with Banana Pi M1/M1+/M2/M3 boards and has 800 x 480 Resolution and MIPI or Parallel RGB Interface, 24 bit RGB Touchscreen with no additional cables.










This module is designed specifically for the Banana Pi. The module use the NXP LM75 Temperature chip. The temperature register always stores an 11-bit 2's complement data giving atemperature resolution of 0.125°C. The module use I2C bus to connect to Banana PI. The 3.0V to 5.5V supply voltage range, low supply current, and I²C interface make the LM75 ideal for many applications in thermal management and protection.















Key Features

  • SO (SOP) and µMAX® (µSOP) Packages
  • I²C Bus Interface
  • Separate Open-Drain OS Output Operates as Interrupt or Comparator/Thermostat Input
  • Register Readback Capability
  • Power-Up Defaults Permit Stand-Alone Operation as a Thermostat
  • 3.0V to 5.5V Supply Voltage
  • Low Operating Supply Current 250µA (typ), 1mA (max)
  • 4µA (typ) Shutdown Mode Minimizes Power Consumption
  • Up to Eight LM75s Can Be Connected to a Single Bus
  • Pin- and/or Register-Compatible with Improved-Performance Maxim Sensors Including MAX7500, MAX6625, MAX6626, DS75LV, and DS7505